Step 1:2 is a fill type stitches where the needle penetration on every other row of stitches fall in between the previous rows (half split) making for a flatter appearance to the stitching. In the image at the right, the rows of stitching are numbered. Notice how the stitch points in row 2 and 4 fall in between the points for rows 1 and 3.
|
|
Embroidery Settings For Step Stitches
|
Step Length:
The length of the stitches that make up the fill area, this setting is normally no less than 30 and no larger than 45.
|
|
|
Step to Satin Limit:
|
In very small areas, it is not practical to break the stitches into step. This setting defines the width of the column at which the stitches will be sewn in satin instead of step as shown by the hi-lighted area in the image at the right.
|
|
|
Min Border Satin:
|
The Step length defines the length of the stitches in the fill, however, the area will not always be able to be divided into equal steps. The Step fill also staggers the step lengths so that the stitches do not produce a parallel row effect. The Minimum Border Satin setting sets the shortest stitch allowed in this outer edge stitching
|
|
|
Cornelly:
|
Cornelly is a stitch effect where the lines of the fill are kept parallel all the way to the edge to produce a squared off look. This effect is useful in low densities but will produce larger stitch counts than the traditional edge. It should not be used when densities are below 10 as it will produce very short stitches
|
|
|
|
|
Copyright © 2011, Compucon
Created with the Personal Edition of HelpNDoc: Easy to use tool to create HTML Help files and Help web sites
