Free Step

Step Length:

The length of the stitches that make up the fill area, this setting is normally no less than 30 and no larger than 45.

Step to Satin Limit:

n very small areas, it is not practical to break the stitches into step. This setting defines the width of the column at which the stitches will be sewn in satin instead of step as shown by the hi-lighted area in the image at the right.

Min Border Satin:

The Step length defines the length of the stitches in the fill, however, the area will not always be able to be divided into equal steps. The Step fill also staggers the step lengths so that the stitches do not produce a parallel row effect. The Minimum Border Satin setting sets the shortest stitch allowed in this outer edge stitching

Second Row Offset:

The amount in 1/10 mm to add to the Minimum Border Satin  parameter to offset the second row of stitching 

Third Row Offset:

The amount in 1/10 mm to add to the Minimum Border Satin parameter to offset the third row